Photovoltaic bracket equipment is a special bracket planned for the placement, installation, and solar panel in the solar photovoltaic power generation system.The main types of photovoltaic brackets now used are hot-dip galvanized steel frames, stainless steel frames and aluminum alloy brackets; on weekdays, solar cell modules are installed outdoors, so the brackets will be exposed to sun and rain, corrosion, rust and salt damage!

Photovoltaic bracket equipment manufacturers introduce the design and production process of photovoltaic bracket as follows：

1. After receiving the production task, according to the arrangement of the photovoltaic array in the contract, confirm the series and parallel design plan of the photovoltaic cell module, the cement foundation arrangement design plan and the inclination angle of the photovoltaic array.

2. According to the model of the photovoltaic cell module selected in this contract, confirm the number, size and opening position of the fixed mounting holes of the frame of the photovoltaic cell module.

3. According to the technical plan, confirm whether the photovoltaic bracket has other ancillary requirements such as a fixed lightning protection combiner box.

4. Summarize the above three contents and provide them to the designer for the design of photovoltaic brackets as the design basis.

5. The designer provides the design drawings of the photovoltaic bracket, and the engineering technicians confirm the correctness of the drawings according to the engineering requirements.

6. After the design of the bracket drawing is completed, the official drawing has the design, verification, auditor and design date to confirm it as the later bracket production drawing.

7. The designer provides the detailed list of bracket production in this contract.The detailed list of bracket production includes the total number of sets of brackets, the model and quantity of each set of brackets, the model and quantity of bolts, and auxiliary materials such as elastic pads, flat pads, puncture pads, and nuts.

8. The detailed production list of photovoltaic brackets shall be sent to the production department with the production drawings of the screen cabinet of this contract.

9. The drawings of the photovoltaic bracket are at the designer's office. The designer provides the drawings of the bracket of this contract to the manufacturing department, and the manufacturing department is responsible for the production and packaging of the bracket according to the progress of the contract.

10. In order to facilitate the acceptance, transportation and on-site installation of the bracket, the bracket should be properly packed.Auxiliary materials such as bolts and nuts should be classified and packaged, and it is strictly forbidden to mix auxiliary materials together.

Generally speaking, photovoltaic brackets are distinguished according to the model and material type. If the accessories need to be replaced during the installation and use of photovoltaic brackets, at this time, they must be purchased according to the specific model requirements and material classification, and complete the fixed installation process. When purchasing accessories, you must also go to a regular manufacturer to purchase them, so that you can be sure to achieve good application results after the installation is completed, so that the solar panel will become more stable and usable during the installation and use process.